Why RO needs antiscalant
In reverse osmosis, salts concentrate 3–10 times in the reject stream. At 75 % recovery the concentration factor is 4×, which pushes calcium carbonate, calcium sulphate, barium sulphate, calcium phosphate and silica beyond saturation. Without an antiscalant, scale forms on the last-stage membranes, flux drops and differential pressure rises.
Components and roles
| Component | Main target |
|---|---|
| Phosphonates (ATMP, HEDP, DTPMP, PBTC) | CaCO₃, CaSO₄, BaSO₄ threshold inhibition |
| AA/AMPS / terpolymer | Calcium phosphate, silica, iron, colloid dispersion |
| PAA / MA/AA | CaCO₃ crystal modification, dispersion |
Starter formulations (% as supplied)
| Feed water type | Formula |
|---|---|
| Brackish / borewell (carbonate + sulphate) | ATMP 50 % – 20; ZEELCHEM™ 3100 – 20; ZEELCHEM™ 1000 – 10; RO water to 100 |
| High silica / iron | DTPMP – 15; ZEELCHEM™ 7000 – 25; RO water to 100 |
| Phosphate-rich (recycled water) | PBTC – 15; ZEELCHEM™ 3100 – 25; RO water to 100 |
Note: Check membrane-manufacturer compatibility, avoid cationic contamination, and validate with projection software and field monitoring. Ready-made ZEELCHEM™ RO antiscalants are available in the full product range.
Dosage calculation
Antiscalant (kg/day) = feed flow (m³/h) × 24 × dose (mg/L) ÷ 1000. For example, a 20 m³/h RO at 3 mg/L uses 20 × 24 × 3 ÷ 1000 = 1.44 kg/day. Try the flow-based mode of the dosage calculator.
Dosing point and good practice
- Dose after the multimedia filter and before or after the cartridge filter, with a static mixer.
- Do not dose upstream of a coagulant, because the antiscalant may react with cationic polymers or iron/alum coagulants.
- Dilute stock with RO permeate; keep tanks covered against biofouling.
- Monitor normalised permeate flow, salt passage and ΔP per stage.
FEATURED PRODUCTZEELCHEM™ 3100 – Co-polymer of AA/AMPS
Sulphonated copolymer for calcium phosphate, zinc, iron and silica control in high-stress cooling and RO systems.
FAQ
What is the typical RO antiscalant dose?
About 2–5 mg/L on feed water, set by projection software.
Can PAA alone be used as RO antiscalant?
It controls CaCO₃ moderately, but blends with phosphonates and sulphonated polymers are far more robust.
Where is antiscalant dosed in RO?
After pre-filtration, near the cartridge filter, before the high-pressure pump.
More from ZEEL PRODUCT: zeelproduct.com · zeelproduct.net · ZEELCHEM™ range · online shop · zeelproductonline.co.in

